1. Curv360
  2. General Information
  3. General Information

Changing APP from AP/EZ

Updated
Chris Nash
Have more questions? Submit a request

CHANGING APP FROM AP/EZ 

  1. First open the Curv App
  2. Type in your password and press 'Next'.
  3. This will take you to the reset screen again.
  4. In the top right hand corner of the screen, it says EZ or AP mode.
  5. Tap this button to select the EZ set up mode.
  6. Follow the on screen instructions.

 

CHANGING THE GATEWAY FROM STA TO AP MODE 

Hold the white button at the top of the gateway for 10 seconds to change the mode from STA to AP mode.

 

RESETTING TRV 

Once the Gateway is reset, you can reset the valves. 

Then please remove the batteries from the TRV, wait 5-10 seconds and then replace. 

Your TRVS are then ready to re-pair

 

 

ADD CONTROLLER / TIMER

 

CONFIRM BLINKING

CURV SMART APP CONTROLS

Articles in this section

See more
Was this article helpful?
0 out of 0 found this helpful
Share

Comments

0 comments

Article is closed for comments.