Understanding the Buttons on the Curv Infrared Heater
1) The panel is on and controlled via the app or thermostat only
2) The Panel is OFF
3) Bypass mode puts the heater Into max heat mode, the heater cannot be controlled by the app or thermostat in this mode
1) This is the WiFi button, there are three states to this switch:
a) Rapid Flashing Light – Searching for connection when switched on.
b) Flashing Pulse Light – Pairing mode enabled
c) Solid Light – The panel is connected to the Wi-Fi
2) The T button also has two states:
a) Solid Light – Pairing mode is enabled for the room thermostat.
b) Flashing Light – When the thermostat receives input, the light will flash on the panel.
LED Light (Mirror Only)
The LED Light on the mirror can be controlled via either the switch on the back of the panel or by triggering the motion sensor at the bottom.
1) Wi-Fi Antenna
2) Temperature Sensor