How to Access the SD Card within your Curv Doorbell
Step 1: Slide off the back-mounting plate from the camera body.
Step 2: On the rear of the Curv Doorbell will be 4 screws in each corner. Using the screwdriver provided, remove the screws and put them safely to one side so they don't get lost.
Step 3: Once all the screws have been removed, carefully remove the back of the Curv Doorbell to reveal the internal electronics.
Step 4: Connected to the motherboard you will see the SD card slot. Push the SD Card inwards to release it from the holder.
Step 5: Please ensure the rubber gasket is placed correctly back onto to the seam.
If this is not correctly aligned the device will no longer be water resistant and can cause damage to the internal electrics.
Step 6: Now you have removed the SD card you can upgrade or replace it. Follow the steps in reverse to assemble the camera back together.