Pairing Thermostat to Curv Heater

Follow this process to pair a Curv thermostat with a infrared heater:

1. On the heater press and hold the T Button for 5 Secs so that the T glows Green
2. Go to the thermostat and press any button to wake up the thermostat.
3. Press and hold the + Button for 3-5 seconds until a number 1 begins to flash in the bottom right corner of the thermostat.
4. Press and hold the + Button again until the number 1 Stays solid this pairs the heater to channel 1.
5. If you would like to pair multiple heaters to the same stat (Max 8 heaters) Follow the steps again up to Step 3 then.
6. When the number 1 begins to flash tap the + button this will then move to Channel 2.
7. Press and hold the 
8. Repeat this process for 3,4,5,6,7,8 if required.